DeLonghi DIHS64 Manuál s instrukcemi stáhnout pdf (Strana 10)

- 19 -

If the domestic appliance is not fitted with a cable and/

or relevant plug, use material suited to the absorption

value indicated on the identification plate and the oper-

ating temperature. At no point must the cable reach a

temperature 50°C higher than room temperature.

If wishing to make a direct connection to the mains, an

omnipolar switch must be interposed with a minimum

opening of 3 mm between the contacts and suited to the

load indicated on the plate and conform to the regula-

tions in force (the yellow/green ground conductor must

not be interrupted by the switch). When the appliance

has been installed, the omnipolar switch must be easily

reachable.

USE AND MAINTENANCE

USE (Fig.2)

Press key A to switch the cooker top on.

Press one of the keys in section B corresponding to the

cooking area you intend to use.

Select cooking power using the + / - keys in section C

(number 9 on the display corresponds to the maximum

temperature and 1 to the minimum).

You can disconnect the cooking area by pressing the

symbols + and - at the same time.

To prevent use or cleaning of the cooker surface by

children, it is possible to block all functions by pressing

the D key.

If the small hotplate is equipped with an extended hot-

plate ring then the second zone will activate when the

corresponding knob P is touched and held for 3 sec-

onds (fig. 2 F).

At this point the hotplate will be ignited and the tempera-

ture may be regulated using the - or + knobs.

BOOSTER:

The appliance is supplied with a Booster (only in the

cooking area indicated in fig.3A – 4A), on the basis of

the model you own.

To activate the Booster, switch the interested cooking

area on at any power level and press key P (fig. 2F). This

allows to reach higher temperatures in a short time dis-

bursing the maximum power possible. Once the function

is activated a red LED and a P will appear on the display

for ten minutes. After this time the cooking area will

automatically return to power level 9.

If the Booster is activated at the same time in other

parts of the cooking area, the power will be slightly

lessened until the end of functioning.

Timer:

The timer can be used for any selected area.

Select the area where you want to use the timer and

then, by pressing the E key, activate the timer and using

+ and - choose the cooking time.

Once cooking time is over, the timer switches off the

area and deactivates the selection.

An acoustic signal can be heard for 30 seconds indicating

the end of timer activation.

IMPORTANT: To avoid damage to the electronic circuitry,

the hob is equipped with a safety device to prevent

overheating.

Should this cut in, wait until the hob has cooled down

before using it again.

MAINTENANCE

Remove any residues of food and drops of grease from

the cooking surface using the special scraper supplied

on request (Fig.7)

Clean the heated area as thoroughly as possible using

SIDOL, STAHLFIX or similar products and a cloth/paper,

then rinse with water and dry with a clean cloth.

Using the special scraper (optional) immediately remove

any fragments of aluminium and plastic material that

have unintentionally melted on the heated cooking area

or residues of sugar or food with a high sugar content

(Fig.7). In this way, any damage to the cooktop surface

is prevented.

Under no circumstances use abrasive sponges or irritat-

ing chemical detergents such as oven sprays or stain

removers.

THE MANUFACTURER DECLINES ALL RESPONSIBIL-

ITY FOR EVENTUAL DAMAGES CAUSED BY BREACH-

ING THE ABOVE WARNINGS.

PLEASE NOTE: IF COOKWARE IS

UNSUITABLE OR NO COOKWARE IS

PRESENT A "U" SYMBOL WILL APPEAR

10.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

Komentáře k této Příručce

Žádné komentáře

DeLonghi DIHS64 Manuál s instrukcemi Strana 10

Komentáře k této Příručce

Související produkty a manuály pro Sporáky DeLonghi DIHS64